SAB Swap for Maryland Stampers

Img 20170212 155958 118

Happy Sunday! We are back fresh from Maryland Stampers Regional with more ideas than we know what to do with. Maryland Stampers is hosting a swap using items from the Sale A Bration catalog. I finished it today and made a video as well. I hope you enjoy it. If you are a Demonstrator in the Delmarva area feel free and email me at and I'll add you to our group.

Paper Dimensions
Card Base 5 1/2 x 4 1/4
Panel 5 1/4 x 4
Seniment Piece 5 1/4 x 4
Outside Piece 5 1/4 x 4
Whisper White Square 3 x 3
Cherry Cobbler Square 3 x 3
DSP 3 x 3
1" Circle punch (scraps)
Cherry Cobbler 4 x 1 /4
DSP 3 3/4 x 1

Place front piece and card base in Big Shot and cut out a circle using 2nd to smallest circle in the Layering Circle Framelits.

Using the 2nd Largest circle framelit in the Stitched Shapes framelits and nesting the second smallest circle from the layering circles framelit send the piece of Cherry Cobbler through the Bigshot.

Run the 3 x 3 piece of DSP through the Bigshot using the 2nd to the largest circle from the Layering Circles Framelits set.

Run the top piece through the Big Shot using the Hexagon impressions texture folder.

Place the piece of 3 x 3 Whisper White card stock centered under the circle opening and lightly trace the inside of the circle. Lightly draw a dot in the center to use for your brad placement later.

Using the Pear Pizzaz sponge 1/2 way up the 3 x 3 piece of Whisper White making sure to always add starting at the bottom so the middle of the cardstock is lightest. Then do the same coming from the top down with Soft Sky.

Stamp your chick image making sure to stay left or right of the center dot you have marked as a brad will secure it there.

Using the watercolor pencils and Blender pen color chick as desired.

Using a pin or your paper piercer pierce a hole in the center where your dot is. Then cut up the the hole a slit. Do the same to the DSP circle you created.

Pierce a hole in the 1" punch out of Whisper White.

Apply washi tape to the dsp piece as a handle.

Place dimensionals on the four corners of the 3 x 3 Whisper White piece making sure to stay away from the circle and adhere to the underside of the top piece.

Adhere your panel using pop dots to hide your work.

Using the Thank you from the Double Take set stamp your sentiment making sure to stay to the right to leave room for your ribbon.

Adhere sentiment that was stamped on the 3 3/4" x 1 piece of DSP to your Cherry Cobbler piece and tie ribbon around then pop up with Dimensionals.

Adhere your remaining piece of WW cardstock into the inside for either a note or sentiment.

Check out my youtube channel for a video on how to complete the project.

Img 20170212 160048 452

Here is the card with the flap closed.

Img 20170212 160048 452

Here is the card with the flap closed.